Fan Assembly. Pgs - Craftmade Ellington E-TIT52ABZ5LKRCI Guia De Instalacion

5. Fan Assembly.
Remove 6 screws and washers from yoke plate
(located on top plate on top of motor housing)
and set aside. Lift yoke plate and top plate to
remove from motor housing and set aside.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide blade through
one of the narrow, rectangular openings on
center band, aligning holes in blade with holes
in blade arm (located inside motor housing).
Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Re-attach top plate and yoke plate to yoke
using washers and screws that were previously
removed. Be sure that semicircular cutout on top
plate and yoke plate aligns over electrical wires for
a proper fit. (Also make sure that reverse switch
aligns properly with hole for reverse switch in top
plate--see drawing.) Tighten screws to secure
top plate and yoke plate.
["Fan Assembly" continued on next page.]
yoke
blade
arms
page 4
yoke plate
hole for reverse switch
top plate
blade attachment
screws and washers
center band
on motor housing
reverse switch
blade