Automated Learning Process./ Activating Code - Craftmade Ellington E-TIT52ABZ5LKRCI Guia De Instalacion

9. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
control transmitter.
Install one 9-volt battery (sold separately) in
transmitter. Note: Leave battery connected but
outside of battery compartment until learning
process is complete.
Note: The dimmer switch (labeled ON/OFF and
DIM) has been pre-set to the "ON" position
(DIM). If you do not wish to have dimming
capability, please move the switch to the "OFF"
position (ON/OFF).
Restore electrical power. Within 30 seconds of
restoring electrical power, press the LEARN
button, located on right-hand side at top of the
battery compartment, for 5 seconds or until fan
switches to MEDIUM speed. Test the light and
fan functions to confirm the learning process is
complete--see Section 11.
Place battery in battery compartment and then
replace battery cover on transmitter.
TRANSMITTER
ON/OFF
DIMMER
SWITCH
TRANSMITTER
page 9
(back)
LEARN
BUTTON
ON/OFF
9V
battery
cover
LCD readout
light button
fan button
(front)