USER COMMAND PIN
The User Command PIN can stop the programmed B-TEL99 call cycle/s during an alarm status, and can be used
on the B-TEL99 keypad and on the kepad of the telephone called by B-TEL99 (see "Stop Alarm").
Default setting The B-TEL99 default PIN is 22.
New PIN To program a new PIN proceed as follows:
Access the programming phase...
c
1 Press
2 Enter the new PIN (up to 5 digits 0 through 9)
e
3 Press
to enter and confirm
User Command fast key To create a User Command fast key, press
event of an alarm all the enabled alarm sequences can be stopped by simply pressing
OPTIONS
The eight programmable options are: 1) Alarm Message Management; 2) Number of Call Cycles; 3) Playback Time;
4) Dialling Type; 5) Dial-Tone Check; 6) Voice Answer Detection; 7) Dial-tone type; 8) RESERVED OPTION Time
Adjustment for Pulse Dialling.
n n
Option 1) Message Management
l
Value [1] = Long Common Message When 1 is selected the B-TEL99 will assign the Long Common Message
(32 seconds) to both alarm channels.
l
Value [2] = Two Dedicated Messages When 2 is selected the B-TEL99 will assign a Dedicated Message to each
alarm channel (16 seconds per message).
l
Value [3] = Short Common Message + 2 brief dedicated messages When 3 is selected the B-TEL99 will
assign the Short Common Message (16 seconds) to both alarm channels, and a brief dedicated message to each
alarm channel (8 seconds per message).
F
In the event of an alarm on alarm channel 1, programmed with value 3, the messages recorded by means of
bb1e
commands
will be sent, that is, the brief dedicated message (8 seconds) assigned to alarm channel 1;
bb3e
the Short Common Message assigned to both alarm channels (16 seconds).
Default setting The default setting is 2.
Access the programming phase...
a
1 Press
b
2 Press
1
3 Press
1
2
3
4 Press
,
,o
, for example
e
5 Press
38
1
...
c
1
7
5
6
9
e
c
e
then
consecutively, in this way, in the
e
.
a
b
1
1
e
Telephone Dialler B-TEL99
-
ð
C
1
7
ð
5
6
9
ð
-
-
ð
A
ð
b
ð
1
ð
1
ð
-