Televes T.OX Serie Manual De Instrucciones página 39

b. Identifi er menu
Some DVB-T receivers can present problems
receiving transmodulator channels which share
the same identifi er (transport_stream_id). To avoid
these cases the user can change the following DVBT
output multiplex identifi ers: transport_stream_id
(ts_id), network_id (n_id) and original_network_id
(on_id).
You can choose Auto mode (the identifi ers do not
change) or Manual mode.
When switching from Auto mode to Manual the
identifi ers received by satellite are displayed and
the user can change them.
c. Temperature measurement
menu
The following menu provides an indication of
the unit's current temperature as well as the
maximum recorded. The maximum can be reset by
pressing the key .
The recommended operating margins are as
follows:
• Optimum operation : 0-6
• High temperature: 7-8
• Excessive temperature: 9-10
If the maximum recorded is outside the optimal
range the installation should be adjusted to try to
lower the temperature.
If the DVBS2-COFDM CI modules have been
installed in a housing ref. 5069 and the temperature
of one of the modules is outside of the optimal
operating range, the ventilation unit will have to be
installed ref. 5334. To check whether this change is
eff ective the maximum can be reset and its value
checked after a given time.
d. Versions menu
In this menu the user is shown the fi rmware
versions for the unit and the COFDM (FPGA)
modulator.
e. CAM (MMI) user interface menu
This menu allows access to the conditional access
module (CAM) user interface, for example, to check
versions or card rights:
39
EN