Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO FROTH MILK
WATER PREP:
Do not remove water reservoir cap or
CAUTION:
portafilter until you release the pressure in the unit.
1. Remove the water reservoir cap.
2. Fill the water measuring cup to the steam line
with filtered water and pour into reservoir.
3. Screw cap back onto water reservoir.
2
TIME TO FROTH:
4. Pour in your desired amount of cold milk into the ceramic
mug or a frothing pitcher, but allow enough room for
expansion of the foam (typically 1/3 or 1/2 of the top).
*Frothing texture is highly dependent upon the milk type
used. 2% is recommended; whole milk creates finer
bubbles while skim milk creates larger bubbles.
5
3
5. Place your ceramic mug or frothing pitcher so that the
frothing wand is submerged into the milk.
About 1/2 -1" into the milk.
6. Turn the knob to "Steam. " This will take a few seconds
to heat up before bubbling. You should hear the steam
coming out. If it is silent, it may mean you are out of
6
3
water and no steam is coming out. If this happens,
remove the frothing pitcher from the frothing wand.
When you hear steam coming out, move the ceramic
mug in a circular motion until desired amount of froth is
reached. *It takes about 2 minutes to froth 4 oz. of milk
to 165˚F heat.
6
7. Before removing the ceramic mug from underneath the
3
frothing wand, turn the knob to the "Off" position .
Note: it is extremely important to clean the frothing wand after
every use. Refer to page 11 for cleaning instructions.
10
CLEANING YOUR MACHINE
AFTER EACH USE
Keep your Mr. Coffee
machine running smoothly by
®
taking care of it after every use. Follow these easy
steps to clean your machine:
1. Rinse ceramic mug. Remove the drip tray cover. Empty water
2
or coffee from drip tray. Dry with a clean cloth. Wipe the
exterior of the machine with a damp cloth. Do not use metal
scouring pads or abrasive cleansers.
Do not remove water reservoir cap or
CAUTION:
portafilter until you release the pressure in the unit.
2. Remove portafilter, discard coffee grounds. Lift filter retainer clip
over the filter and hold in place as you discard coffee grounds.
This helps keep filter secured in place.
3
3. Rinse portafilter with fresh water. Please note that the portafilter is
NOT dishwasher safe. Handwash only!
NOTE: If you did not froth milk, skip steps 4-9.
4. Fill water measuring cup to the steam mark with water and pour
into the water reservoir.
5. Screw cap back onto the water reservoir and plug in the machine.
4
6. Fill ceramic mug half way with water and place so that the frothing
wand is submerged into the water.
7. Turn the knob to "Steam" and steam with water instead of milk for
30 seconds. This will help rinse the internal parts of the machine.
8. Once the frothing wand is cool, remove and rinse frothing wand
cover. The frothing wand cover is the black rubber piece at the tip
8
of the frothing wand. Simply pull from the bottom to remove.
9. Wipe down frothing wand with a damp cloth and rinse the frothing
wand cover.
CAUTION: To protect against electric shock, do not
immerse cord, plug or appliance in water or other liquids.
11
Publicidad
