Multifunction Button - KlipXtreme Tranze Manual De Instrucciones

1. Adjustable headband
2. Cushioned ear pads
3. Noise-cancelling LED indicator
4. USB charging port:
Insert the micro-USB plug here to recharge the battery.
5. Noise cancelling on/off button:
When the ANC feature is switched on, the indicator light glows green, so you
can enjoy noise-free audio. Turn off the ANC function when not needed to
extend battery life.
6. Bluetooth® connection LED indicator light
• Alternating blue and red LED indicates that the headphones have entered into
the pairing mode.
• The LED turns solid blue when the wireless connection has been established
or during a call.
• The blue LED blinks once every 4 seconds while streaming music via Bluetooth®.
• The LED lights up red while charging.
7. 3.5mm input jack:
Use this port located in the right ear cup for wired playback. When the supplied
auxiliary cable is connected, the Bluetooth® modes is disabled automatically. You
must turn on the unit again after removing the stereo cable from the headphones.
8. Built-in microphone:
For hands-free calling and conferencing.
9. Previous track/Volume down:
Briefly press this button to decrease the volume level. Press and hold to play
the previous track.
10. Next track/Volume up:
Briefly press this button to increase the volume level (when the maximum level
is reached, the headphones will generate a short beep). Press and hold to play
the next track.

11. Multifunction button

Mode
Press and hold this button for three seconds to switch the
unit on and for five seconds to turn it off.
Power
A tone will be heard to confirm the device is turned on
Once powered on, the device will enter into the pairing
mode. The battery percentage prompt followed by a beep
will be heard to confirm the headphones are ready to pair
Pairing
with a compatible wireless device. To put back in pairing
mode, hold the button for 3 seconds
Briefly press to answer and end an incoming call
Press twice to redial the last number called (on supported
Hands-free
devices)
mode
Press and hold to reject or ignore an incoming call
Briefly press to play and pause media
Playback mode
Function