How To Assemble Your Ceiling Fan - Fanimation The WindPointe FP7300 Manual Del Propietário

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

1. Remove the Hanger Ball by loosening the setscrew

in the Hanger Ball until the ball falls freely down the

Downrod. (Figure 1) Remove the Pin from the Downrod,

then remove the Hanger Ball. Retain the Pin and Hanger

Ball for reinstallation in Step 5.

2. The fan comes with blue, black, white 80˝ wires and

safety cable. Separate & untwist the three wires and safety

cable. Route the wires through the downrod.

NOTE: You will be using either the 6˝ downrod supplied with

your fan or an optional downrod purchased separately.

3. Loosen the two setscrews in the Downrod Support. Align

the Clevis Pin holes in the Downrod with the holes in the

Downrod Support. Install the Clevis Pin and secure with

the Hairpin Clip. (Figure 3) Be sure to push the straight

leg of the hairpin clip through the hole near the end of the

clevis pin until the curved portion of the hairpin clip snaps

around the clevis pin. The hairpin clip must be properly

installed to prevent the clevis pin from working loose. Pull

on the Downrod to make sure the clevis pin is properly

installed.

▲WARN I N G

It is critical that the clevis pin in the downrod support

is properly installed and the setscrews are securely

tightened. Failure to verify that the pin and setscrews

are properly installed could result in the fan falling.

4. Route wires and cable through Motor Coupling Cover

and Canopy on fan shown with open side facing up.

(Figure 3)

5. Reinstall the Hanger Ball (Figure 1) on the Downrod

as follows. Route the three 80˝ wires and cable through

the Hanger Ball. Position the Pin through the two holes

in the Downrod and align the Hanger Ball so the Pin is

captured in the groove in the top of the Hanger Ball. Pull

the Hanger Ball up tight against the pin. Securely tighten

the setscrew in the Hanger Ball. A loose setscrew

could create fan wobble.

6. While pulling up on the hanger ball, securely tighten the

two 3/16-24 x 3/8˝ setscrews in the downrod support. Slide

the Motor Coupling Cover down. (Figures 2 & 3)

7. The fan comes with blue, black, white leads and support

cable. Before installing fan, measure up approximately

6-9 inches above top of Downrod/Hanger Ball Assembly.

Cut off excess wire and strip back insulation ½˝ from end

of wire.

8. All set screws must be checked and retightened where

necessary before installation.

9. You have now completed the upper assembly of your

new ceiling fan. You can now proceed with the hanging

and the electrical wiring of your fan.