Light Kit Assembly-Fp7500Rsp4Lk Only - Fanimation The WindPointe FP7300 Manual Del Propietário

Light Kit Assembly—FP7500RSP4LK ONLY
1. Install included minican bulbs into the sockets. (Figure 1)
CAUTION
Bulb is pressurized and may shatter. DO NOT TOUCH
BULB WITH BARE HANDS. Fingerprints may result in
shorter bulb life. Remove fingerprints with alcohol
prior to use.
To reduce the risk of fire, use 75-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off the
wall switch and allow the bulb to cool for 10 minutes
before relamping.
2. Secure glass bowl to light fitter using supplied nut.
Next, install trim cover followed by the finial. Do not
over tighten. (Figure 2)
3. Install pull chains and fobs. (Figure 3)
4. Restore Power and your fan is now wired to be turned
on and off from the fan and light kit pull chain control.
10
Figure 1
Figure 2
Figure 3