Assembling And Mounting The Fan Blades And Sw Itch Hsg - Fanimation The WindPointe FP7300 Manual Del Propietário

Assembling and Mounting the Fan Blades and Sw itch Hsg

I N STALLAT I ON N OT E
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARN I N G
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
1. Remove and discard the (rubber) motor "stops" by
removing the five screws. (Figure 1)
Blade & Blade Holder Assembly:
2. Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up.
3. Assemble the blade to the blade holder with the carriage
nuts, washer-head screws and the blade cover. Make sure
the bottom edge of the blade is fully seated against the
blade holder.
4. Tighten screws with a screwdriver provided, don't over-
tighten. (Figure 2)
5. Attach assembled blades and blade holders to the motor
hub using the provided screws & lock washers. (Figure 3)
6. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
Housing Switch Cup/Adapter Assembly:
7a. Disassemble the Housing Switch Cup/Adapter assembly
by removing three screws. (Figure 4a)
<<FP7 5 0 0 RSP4 LK ON LY >>
7b. Disassemble the Switch Cup/Adapter Assembly with
Light Fitter by removing three screws. (Figure 4b)
8. Remove one of the three screws in the support
bracket. Slightly loosen the remaining two screws.
Assemble the adapter assembly to the housing support
bracket using the two key slots in the adapter assembly.
Replace the third screw and securely tighten all three
screws. (Figure 5)
Fan Blade
Figure 4a
ADAPTER
ASSEMBLY
8
Figure 1
Blade
Cover
Figure 2
Screw
(2 per blade
holder)
Figure 3
FP7500RSP4LK
Switch Cup/Adapter
Assembly
with Light Fitter
Figure 4b
SCREWS (3)
Figure 5
Blade
Holder