Fuel Supply; Tuning On - Truper DES-330 Instructivo

Fuel supply

• Follow the safety standards for handling fuel (page 5).
• Wait until the motor has cooled down completely
before supplying fuel.
• Set the grass trimmer onto a flat surface.
• Wipe clean around the fuel tank cap to prevent
contamination.
• Slowly loosen the fuel tank cap.
• Use care to prevent spills. Pour the fuel mix into the
tank. Follow the fuel specifications (page
CAUTION
3).
• Before capping the fuel tank check and clean the joints.
• Set immediately the fuel tank cap and tighten with your
hand.
• Clean all fuel spilled.
CAUTION
In a new motor smoke emissions are
normal during and after using for the first time.
Turning on
Start up with a cold motor
• Set the grass trimmer on level ground where the blade
or spool will not make contact with any obstacle.
• Set the switch into the ON position (A).
• Press and release the primer bulb 10 times (B).
• Move the choke lever upwards (C).
• Press simultaneously the trigger release (D) and the
throttle trigger (E). Keep the trigger depressed.
• Pull the starter handle (G) to start the motor. Do NOT
pull more than 4 times to avoid flooding the motor.
• If the motor is not starting, move the choke lever
downwards (H). Pull again the starter handle (I) until the
motor starts. DO NOT pull more than 6 times (although
in cold climate you may need to pull the starter handle
more times).
• If the motor is not starting still, repeat steps from (B)
and on.
• Once the motor starts, leave it running a few seconds in
that position.
• Press and release the throttle trigger to set the motor
idle (K).
• The grass trimmer is now ready to operate. Hold both
handles using both hands and lift it to start the job.
A
E
D
F
C
G
x4
I
x6
K
B
x10
H
ENGLISH
9