Front Brake - Beta REV-3 Manual Del Usuario

3
GB

FRONT BRAKE

FRONT BRAKE FRONT BRAKE
FRONT BRAKE FRONT BRAKE
Check Check
Check Check Check
To check the front brake for wear, simply
observe the caliper from the front, where
it is possible to see the ends of the two
pads. These pads should have at Ieast a
2 mm Iayer of Iining. If this layer is thinner
than 2 mm, replace the pads immediately.
Note: Note: Note:
Note: Note:
Observe the times given on the chart on
pag. 62 when performing the check.
Replacement Replacement
Replacement Replacement Replacement
To replace the pads, proceed as follows:
•Disassemble the disk cover and the
caliper by unscrewing the two screws A A A A A
and releasing the screw B B B B B
•Slide the split pin C C C C C
•Unscrew the screw B B B B B
•Remove the pads D D D D D and replace them
•To reassemble, proceed in the reverse
order.
Note: Note: Note: Note: Note:
To avoid braking problems, pay particular
attention to the correct reassembly of the
split pins.
If the brake disk is removed, apply If the brake disk is removed, apply If the brake disk is removed, apply
If the brake disk is removed, apply If the brake disk is removed, apply
Loctite Loctite to to the the
Loctite Loctite Loctite to to to the the the
reassembling. reassembling. reassembling.
reassembling. reassembling.
58
screws screws when when
screws screws screws when when when