Installation - Chicago Faucets E-Tronic 20 Guia Del Usuario

Chicago Faucets E-Tronic

INSTALLATION

This faucet comes with all the components needed for
installation, however, some tools and supplies are not
included.
• Basin Wrench
• Adjustable Wrench
• Adjustable Locking Pliers
• Plumber´s Putty
• Hex Key (supplied)
• Aerator Key (supplied)
Do not use pipe dope on faucet and supply
connections. Possible solenoid contamination could
occur and will void any warranty.
Mounting of Faucet
Prerequisites
• Supply valve is installed
• Water supply lines are flushed properly
• For AC faucets, power outlet is installed
It is not necessary to unscrew the connection between
braided hose and housing to install the product.
Do not remove protective covering from sensor until
starting up faucet operation.
Do not tighten locknut before step 4 is completed.
Mount cover plate if required. Plumber´s putty is
1
recommended to seal the cover plate to the sink.
Security pin must be located on the left side
2 Mount gasket and put faucet into sink
™ 20 User Guide
Mount bracket from underneath. Place hoses through
3
large opening and mounting rod through small
opening. Make sure flange sits securely against surface
4 Place nut onto mounting rod and tighten with wrench
If faucet was installed with cover plate, secure with
5
basin washer, flat washer and locknut
6
Install outlet and tighten with outlet key (supplied)
Connect braided hose with filter to supply valve
7
Cold water > white label
For AC faucets, please refer to the Plug in or hardwired
transformer installation instructions.
8
Connect to power supply
Result: The faucet is now mounted.
4
Hot water > no label