What To Do If Cloning Fails - Motorola DTR720 Guia Del Usuario

English
• Two Single-Unit Chargers (SUC) for radio
cloning.
• Ensure that the radios are turned off
2 Plug one side of the cloning cable micro-USB
connector to the first SUC and the other end to the
second SUC.
NOTICE:
During the cloning process, no power is being
applied to the SUC. The batteries are not
charged. Only data communication is being
established between the two radios.
3 Turn on the Target Radio and place it into one of the
SUCs.
4 For the Source Radio, perform the following actions:
a Press the Menu/OK → Advanced → Cloning →
Radio Cloning
b Place the Source Radio in its SUC.
c Press the Menu/OK button.
The display shows Cloning....
If successful:
42
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
5 After completing the cloning process, exit the
'cloning' mode by long pressing the Home/Back
button.

What To Do If Cloning Fails

In the event that the cloning fails, perform each of the
following steps before attempting to start cloning process
again:
1 Ensure that the batteries on both radios are fully
charged.
2 Check the cloning cable connection on both SUCs .
3 Ensure that the battery is engaged properly on the
radio.
4 Ensure that there is no debris in the charging tray or
on the radio contacts and the radio contact is
touching the SUC/MUC contact firmly.