Publicidad
Idiomas disponibles
Idiomas disponibles
4. SAFETY
Operating the Quick Release
To Release & Reload the Quick Release Trim Loop:
Trim Loop:
1
To activate the Quick Release Trim
Loop: Grasp the handle of the quick
release trim loop and force it up the
QRTL line, away from your body.
Important:
It is your responsibility
to maintain the proper working order
of the quick release mechanism.
Always inspect this piece prior to
launching your kite. Make sure the
trigger mechanism is properly seated
To Release:
before you ride, and occasionally while
on the water. There are two ways to
do this:
1. Grasp the handle and pull it towards
your body.
2. Briefly unhook from the loop, and
then hook back in.
Release Pics 1-4:
To release, grasp
the handle and force it away from your
body to open the loop.
Reload Pic 1:
Released QRTL.
Reload Pic 2:
Slide the Velcro arm
through the stainless steel loop at the
end of the QRTL.
Reload Pic 3:
Slide the handle down
the line over the Velcro arm.
Reload Pic 4:
Reattach the velcro to
To Reload:
secure the QRTL
Note:
You MUST test your Quick Releases often in order to get used to the way they work; this is the only way for you to
be able to use them fast enough in case of emergency. Remember that the Quick Release devices have a limited lifetime
and you must change them after 250 hours of kiting. Our Quick Releases are developed and designed to be used by a
rider of 80kg or less.
18
English - www.naishkites.com
Quick Release Features
2
3
4
let go of
handle
1
2
3
4
Shift Leash Quick Release Features
Releasing the Shift Leash Quick Release:
Pics 1 & 2
If you need to get totally free of the kite, release the leash quick release by grabbing the red handle and
pushing it away from you.
1
Reconnecting the Shift Leash Quick Release:
Pic 1
Slip the pivot pin through the loop that is still attached to your harness or spreader bar.
Pic 2
Pull the red release tube toward yourself sliding it over the pivot pin.
Pic 3
Keep sliding it back making sure it slides smoothly over the pivot pin.
Pic 4
Pull it all the way back to the black stopper ball to ensure that it doesn't release inadvertently.
Always make sure the handle is in the correct position.
1
velcro
3
CAUTION!
If you are practicing spins, and you continually spin in one direction, the Shift System could be rendered
ineffective by twisted lines. To avoid the potential of twisted lines you should always try to do the same number of spins
in both directions. In addition, you should always check the condition of your Shift line by pulling on your Shift leash
to make sure the Shift line is not bound in any way. If you feel tension on the line you should go to the beach and reset
your lines to eliminate all twists.
4. SAFETY
2
2
4
www.naishkites.com - English
19
Publicidad
