Krampouz GGCIO2 Manual De Instrucciones E Instalación Original página 26

When using the plancha, the cooking juices collector must be fitted in the right place.
(Risk of damaging the handles)
Use
This appliance is for professional use of qualified, trained personnel who have read the
instructions.
IGNITION
- The appliance is ready for operation. Check that the gas inlet is open. Shut off the
appliance's gas inlet immediately if you smell gas. If the smell persists, check the
connection and pressure screw and contact your qualified gas installation
engineer. (See figure 1 page 65)
- For the first ignition after installation, push the lever, set it to the high flame
position and hold it for 5 seconds to bleed the air from the gas pipe to the burner.
Then release the lever.
- Open the valve by turning the lever on the left until it is in the high flame position
(drawing shown on the lever).
- Activate the spark ignition and then push the lever in this position to obtain full
burner ignition.
- Maintain pressure on the lever for 5 to 10 seconds to engage the thermocouple
safety system.
- Then release the lever and allow the burner to heat the cooking plate to the
appropriate temperature.
- Your appliance is ready to be used.
COMMENTS
The first time it is used, you may see some smoke and smell some odours coming from
the appliance.
Cooking juices collector
- 26 -