Krampouz GGCIO2 Manual De Instrucciones E Instalación Original página 29

-
Reposition the injector in the burner hole and tighten both injector support
screws.
-
Clean and tighten the appliance's protection. We recommend that you record
the new configuration on the appliance's information plate and delete the old
one.
-
Place the changed injector in the conversion bag and store it carefully. Then
refer to the start-up procedure.
GGCIO2
-
Turn the appliance, and remove the galvanised steel plate.
-
Push the burner away from the valve.
-
Unscrew the injector with a size 10 wrench and its bracket with a size 13
wrench. Then take the conversion set (set of injectors), as shown in the figure
below). (see figure 3 on page 66-67)
-
Change the injector and its seal, as per the instructions in the correspondence
table of the different types of supply (table on page 27).
-
Return the burner to its initial position and then tighten the two screws to lock
the burner.
-
Clean and tighten the appliance's protection. We recommend that you record
the new configuration on the appliance's information plate and delete the old
one.
-
Place the changed injector in the conversion bag and store it carefully. Then
refer to the start-up procedure.
IDLE FLAME SETTING
When the appliances are set to Butane/Propane gas, the idle screw is turned as far to the
right as possible.
When switching from Butane/Propane gas to natural gas, loosen this screw until you
obtain a good idle flame setting (see the table on page 27). The idle flame is set properly
when the flame is not extinguished when passing quickly from the maximum to the
minimum positions.
Set the idle flame with the cooking plate installed and fastened:
1. Move the lever, pulling it towards you, and remove the ring.
2. Use a small screwdriver to access the adjustment screw located on the periphery of the
thermostat axis. Turn the idle screw through one anticlockwise revolution and refit the
lever (see figure 4 on page 68).
3. Switch the plancha on in the high flame position for 5 minutes
4. Set the lever to the low flame position
5. While looking at the flame under the plate, loosen to increase the idle flame and tighten
to reduce it (see table page 16).
6. Replace the lever and the ring.
- 29 -