GE KAL450 Serie Guia De Instalacion

Installation Guide
Electrical connection (surface mounting):
Manual call point connectors.
1
mounting): Loop data lines;
D
ESCRIPTION
The KAL450 series addressable manual call points are designed
for use in GE Interlogix analogue fire detection systems.
I
NSTALLATION
For general guidelines on fire system planning,
design, installation, commissioning, use and
maintenance refer to the EN54-14 (2001) standard
and local regulations.
Manual call points should be fixed to the wall at a height of
between 1.2 and 1.5 metres from the floor, along emergency
routes with a maximum distance of 30 metres between each. The
call point must be clearly visible, identifiable and accessible.
A flush or surface mounting base (not supplied) is required for
each manual call point.
For surface mounting electrical connections see figure
flush mounting electrical connections see figure
Addressing
Each manual call point requires a numeric address between 128
and 253 for identification purposes. This is set using DIP switches
1-7 located at the rear of the unit (see Table 1: DIP switch address
settings). DIP switch 8 is not used.
M
AINTENANCE
Basic maintenance is reduced to a yearly inspection. Do not
modify internal wiring or circuitry.
T
ECHNICAL SPECIFICATIONS
Operating voltage ...........................................................22 – 38 VDC
Current consumption at 24 VDC (quiescent) ............................90 µA
© (2004) GE Interlogix B.V.. All rights reserved.
Version 3-1 / August 2004
1050788
1
Loop data lines;
Electrical connection (flush
2
Manual call point connectors.
.
KAL450 Series Addressable Manual Call Points
Current consumption at 35 VDC (quiescent)...........................120 µA
Current consumption (alarm)................................................< 3.5 mA
Operating temperature ................................................. -10ºC to 50ºC
2
Storage temperature .................................................... -10ºC to 70ºC
Relative humidity ................................................................. 95% max
Protection index.........................................................................IP205
Dimensions.............................................................. 87 x 87 x 20 mm
Guía de Instalación
Conexionado eléctrico (montaje de superficie):
información;
Conexionado eléctrico (montaje de empotrar):
2
información;
D
ESCRIPCIÓN
El serie de módulos KAL450 es un punto de activación de alarma
manual para una central de control e indicación analógica de GE
Interlogix.
I
NSTALACIÓN
. For
Para información sobre el diseño, instalación, uso y
mantenimiento del sistema, aconsejamos seguir la
norma EN 54-14 (2001) y normas locales.
Por lo general, todo pulsador de alarma se instalará en la pared,
en rutas.de salida de emergencia, sin que hay que recorrer más
de 30 m para llegar a uno de ellos, y a una altura entre 1,2 y 1,5 m
del suelo. Deberá quedar claramente visible, identificable y
accesible.
Para la fijación a la pared y cableado se usará un zócalo base de
conexión para superficie o para empotrar (no incluido) para cada
pulsador de alarma.
Conexionado eléctrico: para un zócalo base de conexión para
superficie ver figura
empotrar ver figura
Installation Guide
2
Conectores de pulsador
Conectores de pulsador de alarma.
. Para un zócalo base de conexión para
.
1
Línea de
de alarma.
1
Línea de