After You Have Finished Using Your Appliance; Working With The Blender - Silvercrest SKMP 1300 B3 Instrucciones De Uso

CAUTION! PROPERTY DAMAGE!
► To prevent the appliance from being
overloaded, do not exceed the specified
maximum filling quantities .
If the appliance is labouring: switch off the
appliance, remove half of the dough and
knead each half separately .
5) Push the release lever 2 upwards and push
the swivelling arm 1 into its working position
with the mounted inset facing downwards .
6) Push the lid 9 onto the mixing bowl 6 .
NOTE
► If desired, you can mount the filling nose 8
onto the lid 9:
–
Rotate the lid 9 a little until the opening
is pointing at you .
–
Hook the filling nose 8 into the eyelets
in the lid 9:
You can now add ingredients, even while the
device is in operation .
7) Turn the rotary switch 3 to the required setting
(cf . section "Speed Levels") .
■ 56 │ GB │ MT
After you have finished using your
appliance
1) Switch the appliance off using the rotary
switch 3 .
2) If mounted, remove the filling nose 8 .
3) Remove the lid 9 from the mixing bowl 6 .
4) Push the release lever 2 upwards and move
the swivelling arm 1 to the highest position .
5) Remove the inset 0 q w from the drive shaft
7 by pushing the inset 0 q w against the
drive shaft 7 and simultaneously rotating
it clockwise (direction
remove the inset .
6) Remove the mixing bowl 6 by rotating it
anticlockwise and lifting it off the base .
7) Clean all parts of the appliance (see section
"Cleaning and care") .

Working with the blender

WARNING! RISK OF INJURY!
► Allow hot fluids to cool to a lukewarm tem-
perature (approx . 30–40°C) before pouring
them into the blender t .
WARNING! RISK OF INJURY FROM
SHARP BLADE / ROTATING DRIVE!
► Never put your hand into the blender t
while it is attached!
► Only remove the blender t when the blade z
is at a complete standstill .
► Only use the blender t with the lid r with
measuring cup e firmly in position .
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket .
This will prevent the appliance from becoming
switched on again unintentionally .
8)
) . Now you can
SKMP 1300 B3