Wayne Dalton 8000 Instrucciones De Instalación Y Manual Del Usuario página 15

6
Bottom Bracket
Tools Needed:
Align center hole of bottom bracket
with hole #3 hole in end stile of bottom
Power Drill
section. Fasten with
(2) 1/4"- 20 x 11/16" self drilling
7/16" Socket
screws and (1) 1/4"- 20 x 5/8"
Driver
tamper-resistant self drilling screw as
shown.
NOTE: Only doors provided to
professional installers, who have
required tools will be supplied with a
tamper-resistant fastener. Use
(1) 1/4"- 20 x 11/16" self drilling screw
in bottom bracket, if not provided with a
tamper-resistant screw.
NOTE: Bottom section can be identifi ed
by the factory attached bottom astragal
and by the bottom bracket warning
labels on each end stile.
7
Counterbalance Cables
IMPORTANT: RIGHT AND LEFT HAND IS
Tools Needed:
ALWAYS DETERMINED FROM INSIDE THE
None
GARAGE LOOKING OUT.
NOTE: For door section identifi cation see
page 4.
Uncoil the counterbalance cables and
slip the loop at the ends of the cables
over each milford pin on the bottom
section.
Insert a roller with a space into bottom
bracket of the bottom section.
Repeat for other side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2" excess astragal on
either side, trim astragal even with door
section.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
1
2
BOTTOM BRACKET
3
4
5
6
7
7
BOTTOM
BRACKET
6
5
4
3
2
1
END STILE HOLE
BOTTOM
PATTERN
BRACKET
(LEFT SIDE IS SHOWN.
RIGHT SIDE IS
OPPOSITE.)
BOTTOM SECTION
MILFORD PIN
BOTTOM SECTION
ASTRAGAL
(2) 1/4"- 20 X 11/16"
SELF DRILLING
SCREWS
(1) 1/4"- 20 X 5/8"
TAMPER-RESISTANT
SELF DRILLING
SCREW
WARNING
LABEL
BOTTOM
SECTION
BOTTOM
BRACKET
ROLLERS
HINGE TUBE
ROLLER SPACER
15