SRAM Avid Juicy 3 Manual Del Usuario página 7

English
2
PREPARE THE CALIPER
Elixir CR Mag/Elixir CR/Elixir R/Elixir 5
A. Remove the wheel from your bike. Remove the brake pads and spreader
clip from the caliper and insert the appropriate Bleed Block. This will
help prevent system overill and keep DOT luid from contaminating your
brake pads.
B. Use the T-10 Torx wrench to remove the caliper bleed port screw from the
banjo bolt (Elixir R/Elixir CR/Elixir CR Mag) or caliper body (Elixir 5).
C. Make sure the luid in the 1/2 full syringe is pushed all the way to the tip
(no air gap!), then thread into the caliper bleed port.
CODE/CODE 5
A. Remove the wheel from your bike. Remove the brake pads and spreader
clip from the caliper and insert the appropriate Bleed Block. This will help
prevent system overill and keep DOT luid from contaminating your brake
pads.
B. The Code caliper features two bleed port screws on either side on the
banjo itting. It's recommended that you use the bleed port on the left side
of the banjo itting during normal bleeding. Use the T-10 Torx wrench to
remove the caliper bleed screw from the caliper body.
C. Make sure the luid in the 1/2 full syringe is pushed all the way to the tip
(no air gap!), then thread into the caliper bleed port.
Juicy 3
A. Remove the wheel from your bike. Remove the brake pads and spreader
clip from the caliper and insert the appropriate Bleed Block. This will help
prevent system overill and keep DOT luid from contaminating your brake
pads.
B. Use the T-10 Torx wrench to remove the caliper bleed port screw from the
center of the banjo bolt.
C. Make sure the luid in the 1/2 full syringe is pushed all the way to the tip
(no air gap!), then thread into the caliper bleed port.
8
Hydraulic Disc Brake Hose Length Adjustment & Bleed Guide
E L I X I R
E L I X I R
5
95-5015-019-000 Rev B
Hydraulic Disc Brake Hose Length Adjustment & Bleed Guide
3
PREPARE THE LEVER
Reach Adjust
For models equipped with Reach Adjust, ensure that the reach is not adjusted so far out that it causes the lever blade to
bottom out on the lever body. Doing so can make bleeding the brake impossible.
OR
E L I X I R
Pad Contact Adjust
For Elixir models equipped with Pad Contact Adjust, rotate the adjuster, until it stops, in the direction opposite the arrow
on the adjuster knob. Then rotate the adjuster back just enough to place the bleed screw at it's highest point.
For Code models equipped with Pad Contact Adjust, rotate the adjuster, until it stops, in the direction opposite the arrow
on the adjuster knob.
E L I X I R
On the Lever
A. Use the T-10 Torx wrench to remove the lever bleed port screw.
B. Make sure the luid in the 1/4 full syringe is pushed all the way to the tip (no air gap!), then thread into the lever bleed
port.
Note: it is not necessary to reposition the angle of the brake lever on the handlebar. You may have a small amount
of DOT luid drip from the bleed port screw, this is normal. Just have a towel handy to wipe off any excess after the
syringe is installed.
Copyright © 2009 SRAM, LLC
OR
CO D E J U I C Y
CO D E
English
9