Replacing The Battery; Troubleshooting; Nothing Is Indicated On The Lcd Display; Lo" Is Indicated On The Lcd Display And The Scales Switch Off - Silvercrest SPW 180 E1 Manual De Instrucciones

8.3. Replacing the battery

Replace the battery when it is empty. To replace the lithium battery
CR2032, open the cover of the battery compartment (3) at the rear
of the bathroom scales by slipping your finger into the slot on the side
of the battery compartment (3). Now remove the cover of the battery
compartment (3).
To remove the battery, push it down a bit (see the direction of the
arrow in the illustration). You can then remove the battery from the
holder.
Then insert a new lithium battery CR2032. Pay attention to the
polarity when inserting the battery. This is indicated in the battery
compartment (3), and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining illustration.
Then replace the cover on the battery compartment (3). The
bathroom scales are now ready to use.

9. Troubleshooting

9.1. Nothing is indicated on the LCD display.


The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".

The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".

9.2. "Lo" is indicated on the LCD display and the scales switch off.


The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. Please note the instructions in the section "Replacing the battery".
9.3. "USEL" is indicated on the LCD display and the scales switch
off.

An error has occurred and the bathroom scales cannot measure your weight. In this case,
step off the tread (2) of the bathroom scales and step on it again. The weight measurement
starts again.
SilverCrest SPW 180 E1
English - 45