COLTRI CNG-20 Manual De Uso Y Mantenimiento página 4

Compressore ad alta pressione per gas metano
Tabla de contenido

Publicidad

ENGLISH
QUICK GUIDE
WARNING:
- This guide is intended only as a rapid introduction to use of
the compressor.
- This guide is not meant to replace the use and maintenance
manual.
- This compressor must not be used before reading the
entire use and maintenance manual.
PRELIMINARY TASKS:
- position the compressor in the selected area (see chap "5");
- check the oil level (see section "7.8");
- connect the compressor to the gas take-off (see chap. "5.3.2");
- connect the control panel to the mains connection socket (see chap.
"5.3.3");
- check that the cooling fan rotates in the direction indicated by the arrow
on the cover; if it turns the other way invert two of the three phases on
the mains power (see section "6.1.1");
- connect up the refill hp hose (see section "7.11");
- check the pressure switch is working (see section "6.2.1").
REFILLING (see chap. "6.5"):
- fit the hose connector (a) onto the vehicle connector (b);
- set the selector switch (c) to ON;
- start the compressor (d);
- the compressor shuts down automatically when the pressure reaches
200/250bar (2900/3626PSI);
- disconnect the connector (a) from the vehicle (b).
MAINTENANCE:
- periodically replace the intake filter (see section "7.6");
- periodically check the lubricating oil (see section "7.8");
- periodically replace the lubricating oil (see section "7.8");
- check transmission belt tension and if necessary change them (see
section "7.10");
- periodically change the filtration cartridge (see section "7.9");
- periodically replace the refill hoses (see section "7.11").
c
Q.EL 7.5KW
HOUR
GAS
MAIN SWITCH
METER
TEMPERATURE
I ON
FEEDING
FAULT
WRONG
LOW OIL
GAS
TEMPERATURE
VOLTAGE
MOTOR
ROTATION
LEVEL
ALARM
1° STAGE
2° STAGE
3° STAGE
SUCTION
PRESSURE
PRESSURE
PRESSURE
PRESSURE
ALLARM
ALLARM
ALLARM
TOO LOW
COMPRESSOR
START
STOP
AT WORK
d
4 - 52
OPERACIONES PRELIMINARES:
- coloque el compresor en el lugar preelegido (véase cap. "5");
- compruebe el nivel del aceite (véase cap. "7.8");
- conectar el compresor a la toma de gas (véase cap."5.3.2");
- conectar el tablero eléctrico a la toma de alimentación de la red (Véase
Cap. "5.3.3");
- compruebe que el ventilador de enfriamiento gire en el sentido indicado
por la flecha que se encuentra sobre el cárter, se gira en sentido contrario
invierta dos de las tres fases entre ellas sobre la alimentación principal
(Véase Cap. "6.1.1");
- conecte el tubo HP de recarga (Véase Cap. "7.11");
- compruebe que el presóstato entre en funcionamiento (Véase Cap.
"6.2.1").
RECARGAR (véase cap."6.5"):
- montar la conexión del látigo (a) en la conexión del vehículo (b);
- ponga el selector (c) en ON;
- poner en marcha el compresor (d);
- el compresor se apaga automáticamente a la presión de 200/250bar
(2900/3626PSI);
- desconectar la conexión (a) del vehículo (b).
MANTENIMIENTO:
- sustituya periódicamente el filtro de aspiración (véase cap. "7.6");
- compruebe periódicamente el nivel del aceite lubrificante (véase cap. "7.8");
- sustituya periódicamente el aceite lubricación (véase cap. "7.8");
- compruebe el tensado de las correas de transmisión y si es necesario
sustitúyalas (véase cap. "7.10");
- sustituya periódicamente lo cartucho filtrante (véase cap. "7.9");
- sustituya periódicamente los latiguillos de recarga (véase cap. "7.11").
CNG-20-24-36
ESPAÑOL
GUÍDA RAPIDA
ATENCIÓN:
- Esta guía sirve única y exclusivamente como introducción
al uso del compresor.
- La presente guía no sustituye en ningún caso al manual de
uso y mantenimiento.
- Se prohíbe usar el compresor sin haber leído
completamente el manual de uso y mantenimiento.
N G
4 /E T C
M C H -2
a
b
MU-CNG202436-0719

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cng-24Cng-36

Tabla de contenido