Vimar RS01 Manual Para El Conexionado Y El Uso página 26

RS01
10 - Troubleshooting:
Problem
The automatic gate system does not
work
You cannot save the remote controls
The remote control does not work
You cannot enter travel programming
As soon as the gate starts it stops and
reverses
During slowdown, the gate stops and
reverses
The gate does not stop with the limit
switches tripping, where applicable
24
Cause
No mains supply
Blown fuses
Control and safety inputs not working
Dip switch 2-1 off and the limit switch inputs not
connected
Safety devices open
Batteries of the remote control discharged
Remote control not compatible with the first one
saved
Reached memory saturation
Batteries of the remote control discharged
Safety devices open
Motor torque not sufficient
Slowdown speed too low
The magnetic sensor cannot read the magnet
EN
Solution
Check the power line switch
Replace the fuses with others of the same value
Check the diagnosis LEDS (stop, STPA and photo
must be on)
Set dip2-1 on for operation without limit switches
or connect the limit switches on terminals 17-18-
19 setting dip switch 2-1 off.
Check the diagnosis LEDS (stop, STPA and photo
must be on)
Replace the batteries.
The first saved remote control configures the
control panel to save only rolling-code remote
controls or only dip-switch remote controls.
Delete at least one remote control or add an
external receiver (maximum capacity 200 remote
controls).
Replace the batteries
Check the diagnosis LEDS (stop, STPA and photo
must be on)
Increase the force with the trimmer TR2
Increase the value of trimmer TR3
Move the magnet near to the sensor
Check the LEDS of the limit switches.
Check dip switch number 2-1 for limit switch
presence and dip switch 2-2 for direction of gate
opening.