Microsonic TEL8018C Manual De Instrucciones página 36

Handset Menu function 5: REGISTRATION
This function allows the user to register the handset to a specified base.
Before registering a handset to the base, the base should first be put into subscription mode, by pressing and
key for 5 seconds, the base IN USE/CHARGE LED flashing.
holding
Press SET/OK key, then using ∧ or ∨ key to select REGISTRATION item.
1)
Press SET/OK key to enter.
2)
Press ∧ or ∨ key to select BASE names. (If the handset already has a registration to the base,
3)
there is a "+" on the right side of the display, and you should choose another base number if you
don't want to lose that one)
Press SET/OK key to confirm, the display shows PIN?, key in the 4 digit PIN code for the base (the
4)
default PIN code is 0000)
Press SET/OK key to confirm, and the display will flash "SEARCHING 1"(or 2,3,4)
5)
6) If the base is not found, the handset will return to the previous registration state.
7) If have several handsets, repeat the above steps to register another handset, and the successfully
registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
Note: Press
key to page the handset when difficult to look for.
Handset Menu function 6: TAM
Press SET/OK key, and press ∧ or ∨ key to select TAM. Then press SET/OK key to confirm and enter.
To playback message
When the display shows MESSAGE item, press SET/OK to enter and to listen to messages through the
speakerphone.
Press 4 -- To skip back to the previous message
Press 5 -- To pause and restart the current message
Press 6 -- To skip forward to the next message
During message playing, press ∧ or ∨ key to adjust the playing volume.
Shortcut：You can press and hold
long time to the previous message and
At conversation sate, press and hold
"RECORD". Press and hold
To delete all messages
This will only delete old messages, not new messages.
Press ∨ key to DELETE ALL item, then press SET/OK to enter, the display will show CONFIRM?, you
can press SET/OK to confirm and all old messages will be deleted.
To record a MEMO
You can record memos from the handset, of up to 120 seconds, and they are played back as normal
messages.
1 ） Press ∨ key to MEMO item, then press SET/OK to enter, the display will show RECORD , follows
the voice prompt " Please record memo after the beep ". When you hear the beep tone, start to
speak into the handset microphone to record your memo, and the display will show the length of the
recording.
2 ） Press SET/OK again to end memo recording. There will be a confirmation beep and the display will
key conveniently at on-hook state to play messages, press
key to skip to next message.
key and it will go into 2-WAY records, meanwhile, LCD displays
again if you want to exit 2-way record state.
14
key