Microsonic TEL8018C Manual De Instrucciones página 40

The two internal handsets will be connected. To complete the transfer of the call, the initiating handset
should be placed on the cradle and the external call will now be connected to the second handset.
Party conference call
1. When a call comes, press (HS1)
2. Then press (HS1) INT key once, you will be prompted to select the number of the internal handset with
which you wish to connect.
3. The destination handset will ring.
4. Press (HS2)
5. Press (HS1) the
6. Press to quit the party conference, other parties can still continue to communication.
To Lock/Unlock the keypad
To lock the keypad
Press and hold the
You will hear a beep tone, the icon
While the keypad is locked, any key you press is invalid.
To unlock the keypad
Press and hold the
You will hear a beep tone, the icon
TROUBLE SHOOTING
No signal bar is displayed on the screen
The handset is out of range. Move it closer to the base station
No dialing tone
Check your phone connections
The handset is out of range. Move it closer to the base station
No docking tone
The handset is not placed properly on the base station/ charger
The charging contacts are dirty. Disconnect the power adaptor first and clean the contact with proper
damp cloth.
The handset on the charger does not charge
Make sure the batteries are inserted correctly.
Make sure the handset is placed properly on the base station/ charger
Batteries are defective. Purchase new ones for replace.
No display
Make sure the batteries are charged
Make sure there is power and the phone is connected
The handset no ring
Make sure the handset ring tone is turned on.
Ring volume too low
Check if the ringing volume is set improper, reset it.
Receive only
Check if P/T mode is properly set.
or
or key to accept call.
key then you can talk all together.
key for about 2 seconds.
will appear on the top of display, "HS LOCKED" will appear on LCD.
key for about 2 seconds.
will disappear from the display and it will go back to idle mode.
key
18