Setting The Cable Compensation Circuit Of Video Signals - Panasonic AW-PH360L Manual De Operación

Installation

$ Setting the cable compensation circuit of video signals

(COMP switch of the COMP printed circuit board is set to "OFF" in the default setting.)
1 When using the AW-RP501 controller or the AW-HB505 multiport hub (for
transmissions using composite signals)
When this controller (or multiport hub) has been connected to the pan/tilt head, it is
permissible for the connecting cables to be up to 500 meters long when a 10BASE-T
straight cable (UTP category 5) and coaxial cable (BBC No.PSF1/2M, BELDEN 8281)
are used. However, when the cable length exceeds 300 meters, follow the steps below
to set the cable compensation circuit to "1". (Default setting: OFF)
1. Remove the four screws on the base connector rear panel, and pull out the panel
toward you.
2. Set the COMP switch on the COMP printed circuit board at the back of the panel to "1".
3. Return the panel to its original position and secure it in place using the four screws.
2 When using the AW-RP605A controller
When this controller has been connected to the pan/tilt head, it is permissible for the
connecting cables to be up to 1000 meters long when a 10BASE-T straight cable (UTP
category 5) and coaxial cable (BBC No.PSF1/2M, BELDEN 8281) are used. However,
when the cable length exceeds 500 meters, follow the steps below to set the cable
compensation circuit to "2". (Default setting: OFF)
1. Remove the four screws of the base connector rear panel, and pull out the panel
toward you.
2. Set the COMP switch on the COMP printed circuit board at the back of the panel to "2".
3. Return the panel to its original position and secure it in place using the four screws.
3 When using the AW-RP400 controller
When this controller has been connected to the pan/tilt head, it is permissible for the
connecting cables to be up to 500 meters long when a 10BASE-T straight cable (UTP
category 5) and coaxial cable (BBC No.PSF1/2M, BELDEN 8281) are used.
Since the AW-RC400 cable compensation unit is capable of providing cable
compensation for distances up to 500 meters, there is no need to change the setting
established for the pan/tilt head's cable compensation circuit.
4 When using a personal computer as the controller (for transmissions using
component signals) and the configuration described in 1
A separate cable compensation unit is required if the cables used to connect the pan/tilt
head and controller are to be run over a long distance.
<Note>
OBefore setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan/tilt head is set to OFF.
(The installation work must be performed by your dealer without fail.)
- 11 (E) -