Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
59310 Add-on Unit
ADD-ON CARRIER ASSEMBLY
1. Assembly for add-on unit will be in the OPPOSITE direction of the base
unit that this add-on unit is being connected to. FIG 1.
2. For step 2, refer to page 4 "CENTER SUPPORT ASSEMBLY" steps 2
through 6.
3. For step 3, refer to page 5 "ARM ASSEMBLY".
ATTACHING ADD-ON UNIT TO BASE UNIT
1. Remove caps from base unit. FIG 2.
2. Engage tab on add-on unit with slot on base unit. FIG 3.
3. Secure with (2) M12x1.75x100 button head screws (T), (2) 12mm Lock
washers (H) and (1) add-on support plate (S). FIG 4 & 5.
4. Tighten screw to 35 ft. lbs. with supplied allen wrench (K).
LOADING BIKES TO ADD-ON UNIT
1. For this step, refer to pages 8 & 9 "LOADING BIKES".
5
S
Add-on
support plate
T
Button head screw
H
Lock
washer
PAGE 10
59307_59308_59310_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
1
D
Add-on unit:
Front wheel tube
with cradle-left
2
3
Slot
4
D
Base unit:
Front wheel
tube with
cradle-right
Tab
Publicidad
