Installation And Use - AllPondSolutions EF1+ Manual De Instrucciones

INSTALLATION AND USE

Attach the EF tap to the filter head, pull up the tap handle to allow
1
insertion (1), push the tap into the head tap area (2), fasten the tap
in place using the tap handle (3).
Unclamp all four head and body clips and separate the filter head
2
from the filter body.
Wash through all of the filter media until the water runs clear to
3
avoid it releasing excess media powder / dust into your tank.
Fill the EF ¾ full with aquarium water.
Reassemble the filter head to the filter body.
4
Ensure all four head and body clips are firmly shut.
5
Check that the EF tap is shut to avoid leakage (lever down), and
6
ensure your pipework is setup similar to the set-up diagram below.
Prime the EF by pressing the priming button, press the button with
7
the palm of your hand and keep pressing until all pipes are filled
with water.
Turn on the EF at the power source.
8
1
1
2
4
2
3
5
3 EF1 / EF2
ACTIVATED CARBON
BIO BALLS
CERAMIC RINGS
6
3 EFX
ACTIVATED CARBON
BIO BALLS
CERAMIC RINGS
FILTER FOAM
7