AllPondSolutions EF1+ Manual De Instrucciones página 6

Fill the EF filter body (part 5) with aquarium water, this will
4
aid the priming of the EF.
Prime the EF without the surface skimmer (part 15) attached
5
– this can be re-attached after priming.
Ensure the EF filter body (part 5) is not over stocked with
6
media and foam as this can restrict water flow and affect the
priming function.
Excessive Noise
Ensure the EF impeller is correctly installed, undamaged and free
1
from blockage.
Follow the 'Priming Problems' troubleshooting above.
2
Restricted Water Flow
Ensure the EF impeller is correctly installed, undamaged and free
1
from blockage.
Check all hosing (part 7) and pipework is connected correctly,
2
air tight and unrestricted.
Check the EF filter body (part 5), filter media, hosing (part 7) and
3
all pipework for a build-up of restrictive waste and clean if required.
UV light indicator is not lighting up
If the UV indicator on top of the EF filter head is not lighting up,
1
disassemble the EF and remove the UV bulb from the EF filter
head. Visually inspect the bulb to check that no filaments have
broken inside the UV bulb.
Re-insert the UV bulb, ensuring that it is seated correctly in its
2
holder and re-assemble the EF, test the UV bulb again by pressing
the red switch on top of the EF filter head.
If the UV indicator is still not lighting up it is recommended to try
3
a new UV bulb.
If the UV indicator still does not light up with a new UV bulb
4
inserted, we recommend you contact the supplier of the EF filter.
Still have issues?
Contact the retailer you purchased this All Pond Solutions product
from for further assistance.