Keypad - Buttons - Aquanex AQU36 Manual Del Propietário

KEYPAD - BUTTONS

1. Time of Day - Press and release to display
the time of day for five seconds. Press
button again while current time is displayed
to increment the time 1 minute. Press and
hold for two seconds to rapidly increment
the time.
2. Salt Amount - Press and release to display
the current salt setting, HC (High Capacity),
Sd (standard capacity) and HE (High
Efficiency). Press the button again while
the salt setting is displayed to change the
setting.
HC: This setting maximizes the system
capacity between recharges and will also
use the most salt. This setting can be used
if you have high water hardness or high
water usage.
Sd: This setting uses moderate amount
of salt and provides a medium amount of
water between recharges. This setting can
be used for moderate water hardness or
water usage.
HE: This setting minimizes salt usage for
a recharge (uses the least amount of salt)
and provides the least amount of water
between recharges. This setting can be
used if you have low water hardness or low
water usage.
3. Water Hardness - Press and release to
display the current hardness setting for
five seconds. Press button again while
current setting is displayed to increment the
hardness by one. Press and hold for two
seconds to rapidly increment the hardness
setting.
A hardness setting too high will cause the
system to recharge more often and use
more salt and water than what is needed to
condition your water.
31 • 1/12
1
2
Figure 18 Keypad Buttons
Figura 18 Botones del teclado
3
A hardness setting too low will cause the
system to recharge less often. The system
may pass hard water shortly before it
recharges.
4. Recharge - Press and release to initiate a
recharge. A recharge will start at the next
scheduled time of recharge (12:00 AM). A
flashing regen symbol will be displayed. To
stop a manual recharge press and release
the recharge button a second time. To start
an immediate recharge, press and hold the
recharge button for three seconds. A solid
regen symbol will be displayed. The time
display will show the amount of time left in
the recharge cycle.
During a recharge cycle (the recharge icon
is on steady), a second manual (delayed)
recharge may be called for. Press the
recharge button and release. To stop a
second manual recharge press and release
the recharge button a second time.
During a recharge cycle (the regen icon
on steady), a second manual (immediate)
recharge may be called for. Press the
recharge button a second time for three
seconds. A second immediate recharge
can not be stopped.
NOTE: If a button is not pushed for five seconds,
the controller returns to normal operation mode.
Pushing the recharge button immediately returns
the controller to normal operation.
4