Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Therefore...
DMX channel
"
"
MAPPING DMX CHANNELS
Hold down flash button 7. Disconnect the power. Reconnect the power. Release button 7. This enables
DMX mapping. Mapping remains enabled until the desk is switched off.
When mapped for the first time, channels must be initialised by pressing the flash button relating to the DMX
channel to be mapped. In subsequent uses this is not necessary. Channels must be re-initialised after the desk
has been re-set.
To move a DMX channel to another fader...
1. Select BLIND. To move channel 1 to fader 2, press flash button 1 to initialise the channel, then press
flash button 1 to select channel 1 and then flash button 2 to select faser 2. De-select BLIND.
2. Moving fader 1 now does nothing. Moving fader 2 brings on DMX channels 1 and 2.
To switch off a DMX channel...
1. Select BLIND. To switch off channel 25, for example, select DMX 25 (page 3, channel 1) by turning the
page selector to page 3 and pressing flash button 1 (twice if this is the first mapping of the channel). De-
select BLIND.
2. The result of this is that moving fader 1 gives no output when the page selector is set to page 3, i.e.
DMX 2
To switch on a channel which has been switched off...
1. Select BLIND. To switch on channel 25, set the page selector to page 3 and press flash button no. 1
twice (three times if this is the first mapping of the channel). De-select BLIND.
2. Fader no. 1 on page 3 now has control of the channel.
"
61-72
4 is page
1 flash button 4
15
"
2
34
"
3
"
6
"
3
"
10
Q
12
10
Publicidad
Tabla de contenido
