LightProcessor Q 12 Manual De Instrucciones página 8

PROGRAMMING A SEQUENCE OF SCENES (SCENE CHASE)
1. Press the SCENE button.
2. Select PROGRAM. Note that both the SCENE and CHASE LEDs flash.
3. Press the CHASE button and the SCENE LED goes off.
4. Select one of the twelve chase memories by pressing one of the 'flash' buttons.
5. Recall a scene, using the page select rotary switch and the B sliders.
6. Press the CHASE button to enter this scene into the chase sequence.
7. Recall further scenes and enter them in the same way until the sequence is complete.
8. Select RUN and press SCENE to exit.
A chase will always start to run at its programmed speed. This speed may be varied during the chase run
using the RATE rotary switch, so long as the chase is 'live'. Clockwise is fast; anti-clockwise is slow. The
'live' chase is the one most recently set running.
When the RATE switch is at its minimum setting (anti-clockwise), audio mode is selected. A chase will now
advance according to the internal microphone or to an audio input via the audio jack socket. Note that
inserting a jack plug into the audio socket disconnects the internal microphone.
The next setting to AUDIO is BUMP. Each press of the BUMP button will advance the chase one step.
STOPPING A RUNNING CHASE
Stop a running chase and save any speed changes by pressing CHASE and then the flash button under
which the chase is stored. Alternatively, one or two running chases may be stopped by pressing the CHASE
button twice but this latter method does not save any speed changes.
7