Plug socket X9
Programming button S1
LED H2 (orange)
Rotary switch S2
Module TS4-2 (cutout)
Programming button
LEARNING
LED (yellow)
Module TS4-4 (cutout)
Receiver and hand transmitter
Frequency 433 MHz (in connection with TS4-2 or TS4-4)
Receiver with throw-out aerial, stopper and connecting cable
• Insert plug of connecting cable into receiver.
• Place receiver near door opening to have good receiving
possibility.
• Plug in the other side of connecting cable into plug socket X9
of circuit board TS4 vario.
• Put battery into hand transmitter.
Learning-in of radio for module TS4-2
• Turn rotary switch S2 to position „radio signal" (see picture).
• Press programming button S1 and transmission button
simultaneously (orange LED H2 starts to flash).
• Keep both buttons pressed until orange LED H2 is glowing
permanently.
• The control unit is now adjusted to impulse signal of hand
transmitter.
Learning-in of radio for module TS4-4
• Actuate button LEARNING and keep it pressed -> yellow LED
goes on.
• Actuate hand transmitter -> yellow LED goes out.
• Release button LEARNING and hand transmitter button.
• Repeat procedure.
• The control unit is now adjusted to the hand transmitter.
1 channel hand transmitter with programming cable and battery
Page 13