Teckentrup TS4 Instrucciones De Mantenimiento página 7

F1 Fuse 100mAT
F2 Thermal overload protection motor
K1 Safety relay CLOSE
K2 Safety relay OPEN
K3 3. safety relay (optional)
M1 Motor
T1 Transformer
TA1 Button OPEN
TA2 Button CLOSE
X1 Connector block power supply
X2 Connector block motor
X3 Connector block command units
X3.A Terminal block key switch in
control cover
X3.B Terminal block inner 3-way button
X3.C Terminal block inner film button
X4 Connector block safety elements
X5 Connector block limit switch
X6 Jumper BOTTOM SAFETY EDGE
DEVICE 8.2 kOhm + Fraba OSE-
BOTTOM SAFETY EDGE DEVICE,
as well as Bircher ISAT-BOTTOM
SAFETY EDGE DEVICE or airswitch
contact
X7 Jumper in case of TS4-2,
automatic re-opening
X8 Plug-in connection for additional
modules
Legend
DW = Airswitch
SKS = Closing edge safety device
X9 Terminal block receiver
X11 Terminal block rpm-monitoring
(optional for sectional doors)
S2 Limit switch OPEN (opener)
S3 Safety limit switch OPEN (opener)
S4 Safety limit switch CLOSE (opener)
S5 Limit switch CLOSE (opener)
S6 Additional switch CLOSED
(for airswitch with testing)
S7 Safety switch emergency manual
operation (opener)
S8 Safety device against jumming
and cut-out cable safety device
(opener)
S9 Emergency cut-out (opener)
S10 Wicket door contact (opener)
S11 Additional button STOP (opener)
S12 Additional button OPEN (closer)
S13 impulse button, ceiling pull button,
external radio in two-way wiring
S14 Additional button CLOSE (closer)
S15 Driveway photo cell (opener)
S16 Airswitch (opener)
S17 Limit switch including button,
HALF WAY OPEN (opener) in
external box at the operator
R1 Closing edge safety device
8.2 kOhm, optoelectronic or
electromechanical closing
edge safety device (closer)
Page 7