Ts Basic Module; Press And Release / Press And Hold Open; Search Of Faults - Teckentrup TS4 Instrucciones De Mantenimiento

TS basic module

Faults
Door is neither
opening nor closing.
LED on additional
module does not glow.
Door travels in opposite
direction to button direction.
Door does not travel
to press and hold
CLOSE.
Door does not travel to
press and hold OPEN
No reaction to
remote control.
TS basic module
Search for faults
Dead Man Coding
Press and release OPEN / press and hold OPEN.
For press and hold OPEN, TS basic module has to be plugged in
inverted into the terminal block X8 (additional moduls).
Rolling grills with press and hold OPEN have to be equipped
with a safety device against jamming!
Reason
• Thermal overload protection operator (motor is too hot).
• Safety limit switch is activated.
• Safety device against jamming is activated.
• Cable safety device is activated.
• No mains connection.
• Check control fuse F1.
• Base module is not inserted.
• Crank handle inserted.
• Key switch in housing cover switched off.
• module is plugged in wrongly (coding slot).
• Check mains supply for right-turning rotation field.
• S6 not adjusted for airswitch with testing.
• Check closing edge safety device.
• Check driveway photo cell.
• 1 st phase is missing.
• TS basic modul is wrongly plugged in.
• Check receiver.
• Transmitter not adjusted to TS4-2 or TS4-4.
• Check battery in transmitter.
• Check closing edge safety device.
Coding for press and hold
Page 9