Publicidad
Idiomas disponibles
Idiomas disponibles
MODEL ICBBW-30 INSTALLATION
Panel Installation
DOOR PANEL
To install the custom door panel, remove the handle side
trim molding. Insert a screwdriver tip into the top corner slot
on the handle side and pop out the trim. Remove the screws
and frame. Refer to the illustration below.
The door has a 6 mm frame for the custom panel to slide
into. If the panel is thicker than a 6 mm, rout an edge around
the panel or mount the panel on a sheet of 6 mm thick
material, then insert into the frame.
Door side trim.
A 3 mm space is required between the backer panel and the
custom panel to allow the panel to slide into the door frame.
Refer to the illustrations below for critical dimensions.
Install handle hardware before inserting the panel. Large
D-style handles are recommend rather than knobs. Screw
heads must be countersunk into the panel.
Slide the panel into the frame.
To reinstall the door trim molding, insert the top of the trim
into grooves at the top of the door and work downward,
snapping the trim into clips on the door frame.
CUSTOM
SPACER
SPACER PANEL
PANEL
CUSTOM PANEL
BACKER PANEL
BACKER
PANEL
TRIM
8 mm
min
19
6 mm
mm
3 mm
3 mm
(OVERLAY)
typical
Panel assembly cross section
Panel assembly rear view.
(overlay).
GRILLE PANEL
Remove the bottom grille frame by extracting the lower
two corner screws from each side of the grille assembly.
Refer to the illustration below.
With the bottom section removed, slide the custom grille
panel into the frame. If the panel is thinner than 6 mm, a
filler material will need to be installed to achieve a proper
fit. Once the panel is installed, reattach the bottom grille
frame by sliding the corner brackets back into position, then
reinstall the four corner screws.
PANEL
BOTTOM
GRILLE
FRAME
Grille frame assembly.
SIDE PANEL
When installing a custom side panel, an accessory kit is
required and is available through an authorized Sub-Zero
dealer. Stainless steel and white enamel side panels are also
available from an authorized Sub-Zero dealer.
IMPORTANT NOTE:
The use of side panels may change the
width of the opening.
A custom side panel must be a minimum of 610 mm deep
and 13 mm thick. Routing will be necessary for the side
panel to fit flush against the side of the unit. Refer to the
illustrations below.
The height of the side panel will vary
IMPORTANT NOTE:
with the height of the grille. Verify the finished height before
modifying panels.
610 mm
FRONT
OF SIDE
PANEL
25 mm
48 mm
3 mm
3 mm
ROUT TO
13 mm
48 mm
MAIN
SIDE PANEL
FRAME
ROUTING
25 mm
2134
mm
Routing detail.
102 mm
OPTIONAL
67 mm
TOE KICK
CUT-OUT
Side panel dimensions.
subzero.com
| 11
Publicidad
