Burner Tubes Cleaning Or Replacement - Weber Genesis E-310 Guia Del Usuario

BURNER TUBES CLEANING OR REPLACEMENT

You will need: Phillips screwdriver, flathead screwdriver, and 5/16" nut-driver.
A) Your Weber gas grill must be OFF and cool.
®
B) Turn gas OFF at source.
C) Remove cookbox components - warming rack, grates and Flavorizer
deflectors do not need to be removed.)
Control Panel Removal
To remove control panel:
A) Locate door pin release in door assembly. Using a screwdriver, push down on door
pin release (1) until door detaches from frame assembly. Pull top of door away from
frame assembly (2) and lift door off bottom adjustable hinge pin.
B) Remove control knobs, igniter button, igniter retention nut, and battery (3).
C) Remove screws from wind deflector (4) located underneath the control panel with a
Phillips screwdriver.
D) Tilt end of wind deflector down and slide away to remove (5).
E) Remove igniter module from control panel (6) and remove all four wires from
module.
Remove screws from underside of control panel with Phillips screwdriver (7).
F)
G) Lift control panel up slightly, tilt up front edge and gently lift up and away (8).
18
MAINTENANCE
bars. (Heat
®
5
1
2
3
4
7
6
8