Trouble Shooting Guide; Mounting Configurations - RAMSEY WINCH RPH-20,000 Manual De Funcionamiento, Reparación Y Mantenimiento

TROUBLE SHOOTING GUIDE

CONDITIONS
OIL LEAKS FROM WINCH
WINCH RUNS TOO SLOW
CABLE DRUM WILL NOT
FREESPOOL
BRAKE WILL NOT RELEASE
WINCH MOUNTING CONFIGURATIONS
R. H. MOUNTING
CONFIGURATION
POSSIBLE CAUSE
1. Seals damaged or worn.
2. Too much oil.
3. Damaged gaskets.
1. Low flow rate
2. Hydraulic motor worn out.
1. Clutch not disengaged
1. Air in hydraulic system
ANGLE SIDE
6
CORRECTION
1. Replace seal.
2. Drain excess oil. Refer to
OPERATION.
3. Replace gaskets.
1. Check flow rate. Refer to
Hydraulic Systems requirements,
page 5
2. Replace motor.
1. Check air pressure to clutch
cylinder 90 PSI minimum
required-Refer to page 12.
1. Bleed air from brake. Refer to
page 11.
ANGLE SIDE
L. H. MOUNTING
CONFIGURATION