STAYER WELDING AS-XL Manual De Instrucciones página 15

Process
Coated electrodes
MAG
TIG
MIG with heavy
Metals
MIG with light
Alloys
Finish-to-air arc
Plasma
Jet cutting
Micro plasma
Arc welding
NOTE – The tern "heavy materials" applies to steel, alloy steel, copper and its alloys, etc..
2. Min. (0.2 second) In low amperage, quick cooled,
situations were immediate control is desired.
Initial position recommended is central one.
It is recommended to start adjustment at mid position
adjusting until the adequate adjustment is obtained.
4.5. Setting grinding
You can adjust your mask (AS-XL ) as work either welding
or grinding.
1. To enable the mask grinding AS-XL just put the
controller in position 13 GRIND.
4.6. Checking the status of the filter
The filter has a self-diagnostic systems. Press button 20
"reset" and the mask should darken immediately if it is
in a good state. Do not use the machine and take it to
Technical Support if it does not darken.
5. MAINTENANCE
5.1. Cleaning and Storage
Clean the equipment using a soft cloth, a medium soap
and lukewarm water. Do not use solvents.
Clean the automatic filter with a cloth that does no loose
fibers. Do not project sprays in equipment nor submerge.
Store equipment in a place that has a medium temperature
and is clean and dry without any dust.
Since the inner part of the outer filter can be get dirt with
the welding smoke is recommended to be dismantled and
cleaned regularly.
ENGLISH
Recommended use of different degrees of protection to EN 169 arc welding
30 40 60 70 100 125 150 175 200 225 250 300 350 400 450 500 600
9 10
9 10
9 10
9
9
10
9
30 40 60 70 100 125 150 175 200 225 250 300 350 400 450 500 600
15
Current intensity (A)
11 12
11 12
11 12
10 11 12
10 11 12
10 11 12 13
11 12
10 11 12
5.2. Replacing the protective lenses
The automatic filter 3 has two protective lens to protect
the other lens from smoke flying particles and arc spatter
during the welding process.
Use only original filters supplied by distributor.
5.3. Replacing the exterior protection
To remove the protective filter:
1. Press downwards the flaps of the buttons 17-18, on
both sides of the transparent screen.
2. Pull the screen out while pressing the flaps that
release protector 6.
5.4. Replacing the interior protection
1. Remove the interior protector 2 with index finger in the
groove supplied at upper side of filter.
2. Place the interior protector 2 by slightly bending in a
way so that it can be inserted into the four highlighted
corners.
3. Remove the protective film from the surface.
5.5. Replacing the harness
If the harness 8 is broken or does not adjust correctly,
proceed with its replacement.
Only use original harness that is supplied by
an official distributor.
Extract the harness by loosening knobs and nuts (13) and
separate the screws (12).
Replace with new harness using the screws (12) and nuts
(13) respecting the insertion of the angular adjustment
dock (9).
15
13
13
13
13
13
13