Machine Programming; Programming Menu; Service Menu; Programming Commands - LAVAZZA LB2210 Manual De Instalación Y De Uso

Note: the activation cycle cannot and must not be interrupted.
The machine brings the brew group to the working position and dispenses
water from the coffee spout. The display will show:
Enable filter
in progress
Wait please ...
The machine dispenses a preset quantity of water for correct activation of
the new "Aqua Prima" filter.
When the cycle is complete, the display will show:
5.
Enable filter
Exit the service menu. The machine will go back into the normal operating
mode.
Empty the dreg drawer of the fi lter rinse water.
Note: set machine to the water hardness value which is immedi-
ately below the measured value. If 3 squares changed in colour,
then the value to be set is 2.
Now the machine is ready to dispense drinks.
10 10

MACHINE PROGRAMMING

MACHINE PROGRAMMING
All the operations described in section 10 must be performed
exclusively by your service provider or a specialised technician,
who must organise all the operating sequences and use suitable
means to ensure strict compliance with current safety regulations.
The specialised technician or service provider can change some machine op-
erating parameters according to the personal needs of users.
There are two menus that can be used:

1 Programming menu;

2 Service menu.

10.1 10.1 Programming menu Programming menu
To access the programming menu, proceed as follows:
1 Turn off the machine by pressing the ON/OFF switch,
2 Press the "large coffee" button and simultaneously turn the machine back
on by pressing the ON/OFF switch.
Section 10.4 lists all the functions available in this menu.
The menu must be PASSWORD protected.
The PASSWORD must be set during the machine initialisation
phase to prevent access of unauthorised personnel.
• 14 •
10.2 10.2 Service menu Service menu
To access the service menu, proceed as follows:
1 Turn off the machine by pressing the ON/OFF switch,
2 Press the "STOP" button and simultaneously turn the machine back on by
pressing the ON/OFF switch.
Section 10.5 lists all the functions available in this menu.
The menu must be PASSWORD protected.
The PASSWORD must be set during the machine initialisation
phase to prevent access of unauthorised personnel.
10.3 10.3

Programming commands

Programming commands
When you access the machine programming or service menu, the keys take
on different functions.
"Page up/edit"
This key enables you to:
1 browse the pages of a menu;
2 change parameters once they
have been made editable with
the ENTER key.
"Page down/edit"
This key enables you to:
1 browse the pages of a menu;
2 change parameters once they have
been made editable with the ENTER
key.
"Select/confi rm" (ENTER)
This key enables you to:
1 select the function displayed;
2 make a parameter/value editable;
3 confi rm a parameter/value once it
has been made editable.
"ESC"
This key can be pressed to exit without
saving changes to the edited or select-
ed parameter.