Removing/Assembling The Refrigerator Doors; Removing The Right (Refrigerator) Door; Removing The Left (Freezer) Door - LG LSXS22423 Serie Manual Del Usuario

12 INSTALLATION
Removing/Assembling the
Refrigerator Doors
When it is necessary to move the refrigerator
through a narrow opening, removing the doors
is the recommended procedure.
WARNING
y If your entrance door is too narrow
for the refrigerator to pass through,
remove the refrigerator doors and move
the refrigerator sideways through the
doorway.
y Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
y Disconnect the electrical supply to the
refrigerator before installation. Failure
to do so could result in serious injury or
death.
y Do not put hands, feet or other objects
into the air vents or bottom of the
refrigerator. You may be injured or receive
an electrical shock.
y Be careful when handling the hinge and
stopper. You may be injured.
y Remove food and bins before detaching
the doors and drawers.
NOTE: Before removing the doors, remove the
base grille. See Installing the Base Grille for
instructions.

Removing the Right (Refrigerator) Door

(1)
(2)
(3)
(4)
T ype 1
1. Open the door. Remove the top hinge cover
screw (1).
2. Use a flat blade screwdriver to pry back the
hooks (not shown) of the hinge cover (2)
from the top of the refrigerator cabinet. Lift
up the cover.
(5)
(3)
Rivet
(4)
(5)
T ype 2
3. Rotate the hinge lever (3) clockwise. Lift
the upper hinge (4) free of the hinge lever
latch (5).
NOTE: Regardless of hinge lever type, removal
process is the same.
CAUTION
When lifting the hinge free of the latch, be
careful that the door does not fall forward.
4. Lift the door from the lower hinge pin.
5. Place the door, inside facing up, on a non-
scratching surface.
Removing the Left (Freezer) Door with
Water Line Connection
Pull up the water feed tube while pressing the
area (Figure 1) shown in the figure below. Make
sure the color of the water lines match.
NOTE: If a tube end is deformed or abraded,
trim the part away. Disconnecting the tube
under the door causes about 0.13 gallons (0.5
liters) of water to flow out. Put a large container
at the end of the tube to prevent water from
draining onto the floor.
Figure 1
(2)
(1)
(4)
(5)
(6)
(7)
T ype 1
1. Open the door. Remove the top hinge cover
screw (1).
(5)
(3)
(7)
(6)
Rivet
T ype 2