LG LSXS22423 Serie Manual Del Usuario página 45

Ice & Water
Problem
Water is not New installation or water line
dispensing. recently connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
Water fi lter has been recently
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
Dispensing Refrigerator was recently installed.
warm water.
The water dispenser has been used
recently and the storage tank was
exhausted.
Dispenser has not been used for
several hours.
Refrigerator is connected to the hot
water supply.
Possible Causes
TROUBLESHOOTING
Solutions
Dispense 2.5 gallons (9L) of water (fl ush for
approximately 5 minutes) to remove trapped
air and contaminants from the system. Do
not dispense the entire 2.5 gallon (9L)
amount continuously. Depress and release
the dispenser pad for cycles of 30 seconds
ON and 60 seconds OFF .
Press and hold the Lock button for three
seconds to unlock the control panel and
dispenser.
The dispenser can be set for ice or water.
Make certain that the control panel is set for
the proper operation. Press the Water button
on the control panel to dispense water.
Water will not dispense if any of the
refrigerator doors are left open.
After the water fi lter is replaced, dispense
2.5 gallons (9L) of water (fl ush for approxi-
mately 5 minutes) to remove trapped air and
contaminants from the system. Do not
dispense the entire 2.5 gallon (9L) amount
continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON
and 60 seconds OFF .
The tubing can kink when the refrigerator
is moved during installation or cleaning
resulting in reduced water fl ow. Straighten
or repair the water supply line and arrange it
to prevent future kinks.
Connect the refrigerator to the water supply
and turn the water shutoff valve fully open. If
the problem persists, it may be necessary to
contact a plumber.
Allow 24 hours after installation for the
water storage tank to cool completely.
Depending on your specifi c model, the
water storage capacity will range from
approximately 20 to 30 oz (0.6-0.9 L).
If the dispenser has not been used for
several hours, the fi rst glass dispensed may
be warm. Discard the fi rst 10 oz (0.3 L).
Make sure that the refrigerator is connected
to a cold water pipe.
WARNING: Connecting the refrigerator to a
hot water line may damage the icemaker.
45