Specialty Applications; Installation And Use - Ratcheting/Sliding Beam Anchors - Falltech 7411 Manual De Instrucciones

Welding/Power Transmission: FallTech
manufactured using materials that will withstand high temperatures.
Care must be taken to ensure that other elements of your PFAS are
capable of withstanding temperature and/or electrical hazards. Install
this anchor and rig your PFAS so as to reduce and/or eliminate exposure
to these hazards.

3.4: Specialty Applications

Heavyweight: FallTech
lbs. For users weighing between 310 and 425 lbs (with clothing, tools
and equipment), be sure to utilize this product along with body wear and
connecting devices that are rated appropriately (FallTech Heavyweight
SAL's are black in color and are denoted by model numbers beginning
with 7246 or 8246). Under no circumstances should any user
weighing more than 310 lbs be subjected to more than six feet of
free fall.
Extended Free Falls: For applications where free fall cannot be limited to
6 feet or less, or where the anchor point will be at the walking/working
surface (foot-level tie-off), special care must be taken. See sections 3.3
and 3.5 – 3.9 for additional details, instructions and warnings. For these
applications, FallTech offers its Ironman series of lanyards, which are
rated for free falls of up to 12 feet, with a maximum capacity of 310 lbs.
3.5: Installation and Use – Ratcheting/Sliding Beam Anchors
1. Select the appropriate
based on the work conditions and specific hazards (See Section
3.2 for recommendations).
2. Read, understand and comply with manufacturer's instructions
for each component of your Personal Fall Arrest System (Full-
Body Harness, Connecting Devices, Anchorage Connectors,
etc.). Be sure to choose components that are compatible with
this Beam
component compatibility, be sure to contact FallTech for
additional instructions.
3. Calculate possible swing fall hazards, total fall distance, and
required clearance distance. If you have a swing-fall hazard or
do not have the required clearance distance, STOP and
reevaluate your application and system. Your work location
should never exceed an angle of 15 degrees in any direction in
relation to your anchorage location.
Beam Anchors
FallTech Ratcheting/Sliding Beam Anchor
Anchor. If you have questions about product or
Beam Anchors
have a maximum capacity of 425
16
are