Falltech 7411 Manual De Instrucciones página 20

you to lose your footing. Move with care and deliberation at
all times while working at heights.
12. Do not allow your connecting device to pass under your arm or
between your legs – severe injury or death may result. Also
avoid sharp edges which may damage your connecting device in
the event of a fall.
13. If the beam to which this anchor is attached is sloped or vertical,
the Beam Anchor must be positioned next to a stop which will
prevent the Beam Anchor from sliding or moving in the event of a
fall. Joints between beam sections must be flush and must have
a maximum gap of ½".
14. The Detent-Pin Beam Anchors (model #'s 7485 and 7486)
should never be used for foot-level tie-off, nor should they
ever be rigged for more than six feet of free fall. Improper
rigging could lead to forced disengagement in the event of a fall.
Always mount to the bottom flange of a horizontal, overhead
beam so that the Beam Anchor is located above the level of the
back D-ring on your Full Body Harness at all times.
Once the above steps have been taken, the user will have access to
their work area while walking and moving at normal speeds. It is
important not to make sudden or dramatic movements! When using this
device, care must be taken to be aware of the work environment and any
hazards, obstructions or obstacles that may exist. Be careful of any and
all fall hazards and also be aware of slipping and tripping hazards as
well.
Correct Installation of Detent-Pin Beam Anchor
Fig. 3.2
20