Installation And Use - Beam Trolley - Falltech 7411 Manual De Instrucciones

3.9: Installation and Use – Beam Trolley
1. Read, understand and comply with manufacturer's instructions
for each component of your Personal Fall Arrest System (Full-
Body Harness, Connecting Devices, Anchorage Connectors,
etc.). Be sure to choose components that are compatible with
this Beam
component compatibility, be sure to contact FallTech for
additional instructions.
2. Calculate possible swing fall hazards, total fall distance, and
required clearance distance. If you have a swing-fall hazard or
do not have the required clearance distance, STOP and
reevaluate your application and system. Your work location
should never exceed an angle of 15 degrees in any direction in
relation to your anchorage location.
3. Inspect this
Fall Arrest System in accordance with Section 8 of this manual.
Be sure to consult, and adhere to the instructional
materials, labels and warnings accompanying the other
components of your PFAS as well.
4. Loosen the variable-position yoke and create an opening large
enough to allow the beam flange to fit between the yokes by first
loosening the outer retainer nut and then loosening the inner
retainer nut (see figure 3.7).
5. Position the Beam trolley over the lower flange of the beam so
that the wheels on each of the yokes extend over the flange.
The FallTech Beam Trolley must only be mounted to an
Fig. 3.6
Vertical Beam Anchor (7535)
Trolley. If you have questions about product or
Beam Trolley, and all components of your Personal
26