Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To align the door:
1
Open the door and slightly loosen both screws at
the lower door hinge.
2
Align the door.
3
Tighten both screws again.
Note: The device door is already aligned when the
appliance is delivered. You do not normally need to
align the door.
Three wire connection
1
Connect red wire from oven to red electrical supply
wire (hot wire).
2
Connect black wire from oven to black electrical
supply wire (hot wire).
3
Connect yellow/green ground oven wire to bare
ground electrical supply wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
Combination with combi-steam oven
Fit the steam oven first. Follow the installation
instructions for the steam oven.To achieve the 21
inch (550 mm) installation depth, the connecting cable
needs to follow the slanted edge on the corner of the
housing.
Combination with warming drawer
Fit the warming drawer first. Pay attention to the
warming drawer's installation instructions.
Slide the oven onto the warming drawer and into the
built-in cabinet. When sliding it in, do not damage the
warming drawer's panel.
Check the Installation
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Switch on the circuit breaker.
Verify that elements function properly.
Removal
1
Disconnect the appliance from the power supply.
2
Undo the fastening screws.
3
Raise the appliance slightly and pull it out
completely.
11
/
16
9
Publicidad
Tabla de contenido
