Adjusting The Door; Three Wire Connection; Combination With Warming Drawer - Gaggenau BSP 250 610 Instrucciones De Instalación

Adjusting the door

For precise alignment, the appliance door can be
slightly adjusted.
8
To align the door:
1 Open the door and slightly loosen both screws at
the lower door hinge.
2 Align the door.
3 Tighten both screws again.
Note: The device door is already aligned when the
appliance is delivered. You do not normally need to
align the door.

Three wire connection

1 Connect red wire from oven to red electrical supply
wire (hot wire).
2 Connect black wire from oven to black electrical
supply wire (hot wire).
3 Connect yellow/green ground oven wire to bare
ground electrical supply wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.

Combination with warming drawer

Fit the warming drawer first. Pay attention to the
warming drawer's installation instructions.
Slide the oven onto the warming drawer and into the
built-in cabinet. When sliding it in, do not damage the
warming drawer's panel.