Seav RES 2322 230V Manual De Instrucciones página 10

completed. To memorise a radio control code in channel CH2, perform the
same procedure described above and pressing the SEL key twice.
The memorisation procedure can be repeated up to a max. of 500 codes.
When the memory is full by repeating the programming operation, the CODE
CH1 AND CODE CH2 LEDs will start to flash very quickly, indicating that no
more memorisations can take place.
LONG DISTANCE PROGRAMMING METHOD
The long distance programming of radio controls is obtained by selecting
Dip Switch SW1 in long distance [Pgm mode. In this way the receiver al-
lows programming of the transmission code, without intervening directly
on the SEL key.
The remote transmission code can be programmed as follows: continuously
send a radio control code, which was previously memorised in a channel, for
more than 10 seconds. At this point, the receiver switches to programming
mode, as described below, for both channels.
RULE FOR THE FIRST RADIO CONTROL MEMORISED
The following rule applies when programming radio controls: if the first radio
control to be memorised is a Rolling Code type of radio control, the receiver
will then only accept Rolling Code radio controls, thus assuring increased
intrusion detection safety. If, however, the first radio control to be memorised
is a radio control with a fixed code, the receiver will then accept both radio
controls with a fixed code and radio controls with a Rolling Code.
RESET
If the receiver must be restored to factory configuration (i.e. no code memo-
rised), press the SEL key continuously for 5 seconds. The CODE CH1 and
CODE CH2 LEDs will flash three times quickly and then switch-off.
10
Rev. 1.0 13/02/2018