PALSON Diábolo Plus Modo De Empleo página 38

GB
View of the space divider and control panel
Main view
Operating the space divider:
The space divider is a robot accessory that can isolate a certain area by sending a special infrared
signal, which prevents the robotic vacuum from entering areas you do not which to clean.
Space divider instructions for use and operating mode
No. Name
1
Switch/selector
a Off
b Low
c Medium
d High
Infrared wall signal
2
transmitter
Local infrared
3
transmission point
4 Power LED
1. Open the battery cover before use and insert two batteries (not included) into the compartment.
«D» Check that the batteries are inserted correctly otherwise the space divider will not work.
2. battery duration depends on the selected distance of transmission and the operating time.
Select the appropriate transmission distance and a low transmission power to save battery
power. Do not forget to turn of the unit when not in use.
3. You may notice differences in direction, space divider infrared signal transmission and robot
reception distance due to the surrounding environment and to the movement of the robot during
use. This difference may vary according to the current surroundings and different battery energy
levels in the robot and the space divider.
38
1. Switch/selector
2. Signal head
3. Local infrared transmission point
4. Power LED
You can change between operating modes using the switch
Off, Low, Medium and High
Move the switch
Move the switch to this position to turn off the device
Move the switch
select a distance of up to 4 metres according to the infrared wall
settings
Move the switch
you can select a distance of up to 6 metres according to the infrared
wall settings
Move the switch, then you can adjust the distance of the space divider
The local infrared transmission signal allows the robotic vacuum
to operate 50-100cm outside the range of the space divider without
affecting its performance
The power LED will flash once every 8 seconds until the battery is low;
once you set the switch to Low, Medium and High, the robot will work
as normal
Operating instructions
a. Off
b. Low
c. Medium
d. High
Operating information
to this position to turn off the device
to this option and turn on the device; you can
to the Medium option and turn on the device;
: