Dictator DICTAMAT 50 KP Manual Tecnico página 14

Technical Manual
DICTAMAT 50 KP
3) Fixing the Kevlar Rope
to the Door
Page 02.057.04
C) Installation of the DICTAMAT 50 KP - continuation
The illustration 3b shows the version of the DICTAMAT 50 KP right,
mounted at the right rail end, for doors closing to the right.
Closing
direction of
the door
Ill. 3b
In case the DICTAMAT 50 KP you have at hand is not the correct ver-
sion for your application, please contact our technical department. By
telephone we will explain you the necessary steps for changing to the
needed version (right or left).
ATTENTION: When changing without technical advice, there may
happen a malfunction of the DICTAMAT 50 KP.
To allow for a simple fixing and exact positioning on, in or from below
to the rail, the carrier plate has oblong holes.
To make fixing to the door easy the Kevlar rope has an eyelet for M5
screws. The eyelet can be fixed either to the wheel hanger or directly to
the door leaf. The rope should run as straight as possible and may not
chafe on sharp edges.
Attention: In case the Kevlar rope has accidentally disengaged from
the guiding pulleys of the DICTAMAT 50, it is compulsory to observe the
guiding of the rope corresponding to the illustrations 3a or 3b and to
make sure it runs beneath the rope coming-off prevention device!
© DICTATOR TECHNIK GMBH Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail info@dictator.de • 1043
DICTAMAT 50 KP right,
part no. 700093 or
700094 (rustless)
Fixing oblong holes
for the mounting to
the rail
Ill. 4